![]() This bracket is designed with a lock lever. Tighten the bracket band with a screwdriver. Attach the BRACKET to the handlebar and fit the RUBBER PAD between the handlebar and the band of the bracket. Cut the excess strapping on the cable ties when the installation is finished. Be sure all relative positions are correct, tightening the cable ties so they will not move.ĥ. IMPORTANT: If either a) or b) is incorrect, poor signal input will result.Ĥ. ![]() ![]() Adjust the desired gap by moving both the magnet and the sensor up or down. Make sure the GAP between the magnet and the sensor is within 4mm (1/6 inch). Aline the center of the MAGNET to either of the sensing zones. Adjust the relative position between the sensor and the magnet. Place the RING around the nut to enhance the reliability of the fixed screw. Mount the MAGNET on one spoke of the front wheel and let the magnet face the sensing zones. Mount the SENSOR with 2 cable ties on the front fork with the RUBBER PAD, and let the sensor face the spoke, do not tighten the cable ties before the sensor is placed in the right position.
0 Comments
Leave a Reply. |